Fender Brace / Fender Bars for Mazda 323 BJ 1.8 2WD (1998) improve your car Handling & Stability.

Specification: 3 Points
(Fabrication based on Taiwan models)

Ultra Racing’s Fender bar will spread out the force and strengthen the section, prevent further damage and offer stable handling. Recommend for user of sport absorber.

The forces acting on the car Mazda 323 BJ 1.8 2WD (1998) when cornering. Front and back view.

When any of the wheels loses contact with the road surface, there will be a deviate in handling; each of the suspension system should keep all wheels on the road surface in spite of hard cornering and in change of steering position. It’s always pleasing that that car can be set for a tiny amount of understeer so that it responds predictably to a turn of a steering wheel and the rear wheels to have a smaller dip angle than the front wheels. However this may not be achievable at all times due to the vehicle load, road condition, weather, speed and this consumes excessive time for the driver to adopt.

BEFORE install fender bar on car Mazda 323 BJ 1.8 2WD (1998): The joint between A-pillar and front chassis will be push and twist by the greater shock of impact and drag force, causing damage on chassis.

AFTER install fender bar on car Mazda 323 BJ 1.8 2WD (1998): Ultra Racing’s Fender bar will spread out the force and strengthen the section, prevent further damage and offer stable handling. Recommend for user of sport absorber.

Test cars with installed Ultra Racing’s Front Strut Bar and Rear Anti-roll Bar and without.

Movie of installation of the Ultra Racing’s Fender Brace.